
How To Manage An Asbestos Problem
Asbestos is a mineral fiber. It can be positively identified only with
a special type of microscope. There are several types of asbestos
fibers. In the past, asbestos was added to a variety of products to
strengthen them and to provide heat insulation and fire resistance.
Where Can I Find Asbestos And When Can It Be A Problem?
Most products made today do not contain asbestos. Those few products
made which still contain asbestos that could be inhaled are required to
be labeled as such. However, until the 1970s, many types of building
products and insulation materials used in homes contained asbestos.
Common products that might have contained asbestos in the past, and
conditions which may release fibers, include:
- Steam Pipes, Boilers, and Furnace Ducts insulated with an
asbestos blanket or asbestos paper tape. These materials may release
asbestos fibers if damaged, repaired, or removed improperly.
- Resilient Floor Tiles (vinyl asbestos, asphalt, and rubber) and
the backing on Vinyl Sheet Flooring, and Adhesives used for installing
floor tile. Sanding tiles can release fibers. So may scraping or
sanding the backing of sheet flooring during removal.
- Cement Sheet, Millboard, and Paper used as insulation around
furnaces and wood burning stoves. Repairing or removing appliances may
release asbestos fibers.
- Door Gaskets in furnaces, wood stoves, and coal stoves. Worn seals can release asbestos fibers during use.
- Soundproofing or Decorative Material sprayed on walls and
ceilings. Loose, crumbly, or water-damaged material may release fibers.
So will sanding, drilling, or scraping the material.
- Patching and Joint Compounds for walls and ceilings, and Textured
Paints. Sanding, scraping, or drilling these surfaces may release
asbestos.
- Asbestos, Cement Roofing, Shingles, and Siding. These products
are not likely to release asbestos fibers unless sawed, dilled, or cut.
- Artificial Ashes and Embers sold for use in gas-fired fireplaces.
Also other older household products such as fireproof gloves, stove-top
pads, ironing board covers, and certain hairdryers.
Where Asbestos Hazards May Be Found In The Home
Some roofing and siding shingles are made of asbestos cement.
- Houses built between 1930 and 1950 may have asbestos as insulation.
- Asbestos may be present in textured paint and in patching
compounds used on wall and ceiling joints. Their use was banned in 1977.
- Artificial ashes and embers sold for use in gas-fired fireplaces may contain asbestos.
- Older products such as stove-top pads may have some asbestos compounds.
- Walls and floors around wood burning stoves may be protected with asbestos paper, millboard, or cement sheets.
- Asbestos is found in some vinyl floor tiles and the backing on vinyl sheet flooring and adhesives.
- Hot water and steam pipes in older houses may be coated with an asbestos material or covered with an asbestos blanket or tape.
- Oil and coal furnaces and door gaskets may have asbestos insulation.
What Should Be Done About Asbestos In The Home?
If you think asbestos may be in your home, don't panic! Usually the
best thing is to LEAVE asbestos material that is in good condition
ALONE.
Generally, material in good condition will not release asbestos fibers.
THERE IS NO DANGER unless fibers are released and inhaled into the
lungs.
Check material regularly if you suspect it may contain asbestos. Don't
touch it, but look for signs of wear or damage such as tears,
abrasions, or water damage. Damaged material may release asbestos
fibers. This is particularly true if you often disturb it by hitting,
rubbing, or handling it, or if it is exposed to extreme vibration or
air flow.
Sometimes, the best way to deal with slightly damaged material is to
limit access to the area and not touch or disturb it. Discard damaged
or worn asbestos gloves, stove-top pads, or ironing board covers. Check
with local health, environmental, or other appropriate officials to
find out proper handling and disposal procedures. If asbestos
material is more than slightly damaged, or if you are going to make
changes in your home that might disturb it, repair or removal by a
professional is needed. Before you have your house remodeled, find out
whether asbestos materials are present.
How To Identify Materials That Contain Asbestos
You can't tell whether a material contains asbestos simply by looking
at it, unless it is labeled. If in doubt, treat the material as if it
contains asbestos or have it sampled and analyzed by a qualified
professional. A professional should take samples for analysis, since a
professional knows what to look for, and because there may be an
increased health risk if fibers are released. In fact, if done
incorrectly, sampling can be more hazardous than leaving the material
alone. Taking samples yourself is not recommended. If you nevertheless
choose to take the samples yourself, take care not to release asbestos
fibers into the air or onto yourself. Material that is in good
condition and will not be disturbed (by remodeling, for example) should
be left alone. Only material that is damaged or will be disturbed
should be sampled. Anyone who samples asbestos-containing materials
should have as much information as possible on the handling of asbestos
before sampling, and at a minimum, should observe the following
procedures:
Make sure no one else is in the room when sampling is done.
- Wear disposable gloves or wash hands after sampling.
- Shut down any heating or cooling systems to minimize the spread of any released fibers.
- Do not disturb the material any more than is needed to take a small sample.
- Place a plastic sheet on the floor below the area to be sampled.
- Wet the material using a fine mist of water containing a few
drops of detergent before taking the sample. The water or detergent
mist will reduce the release of asbestos fibers.
- Carefully cut a piece from the entire depth of the material
using, for example, a small knife, corer, or other sharp object. Place
the small piece into a clean container (for example, a 35 mm film
canister, small glass or plastic vial, or high quality resealable
plastic bag).
- Tightly seal the container after the sample is in it.
- Carefully dispose of the plastic sheet. Use a damp paper towel to
clean up any material on the outside of the container or around the
area.
How To Manage An Asbestos Problem
If the asbestos material is in good shape and will not be disturbed, do
nothing! If it is a problem, there are two types of corrections: repair
and removal.
Repair usually involves either sealing or covering asbestos material.
Sealing (encapsulation):
involves treating the material with a sealant that either binds the
asbestos fibers together or coats the material so fibers are not
released. Pipe, furnace, and boiler insulation can sometimes be
repaired this way. This should be done only by a professional trained
to handle asbestos safely.
Covering (enclosure): involves
placing something over or around the material that contains asbestos to
prevent release of fibers. Exposed insulated piping may be covered with
a protective wrap or jacket.
With any type of repair, the asbestos remains in place. Repair is
usually cheaper than removal, but it may make later removal of
asbestos, if necessary, more difficult and costly. Repairs can either
be major or minor.
Asbestos Do's And Don'ts For The Homeowner
- Do keep activities to a minimum in any areas having damaged material that may contain asbestos.
- Do take every precaution to avoid damaging asbestos material.
- Do have removal and major repair done by people trained and
qualified in handling asbestos. It is highly recommended that sampling
and minor repair also be done by asbestos professionals.
- Don't dust, sweep, or vacuum debris that may contain asbestos.
- Don't saw, sand, scrape, or drill holes in asbestos materials.
- Don't use abrasive pads or brushes on power strippers to strip
wax from asbestos flooring. Never use a power stripper on a dry floor.
- Don't sand or try to level asbestos flooring or its backing. When
asbestos flooring needs replacing, install new floor covering over it,
if possible.
- Don't track material that could contain asbestos through the
house. If you cannot avoid walking through the area, have it cleaned
with a wet mop. If the material is from a damaged area, or if a large
area must be cleaned, call an asbestos professional.
Major repairs must be done only by a professional trained in methods
for safely handling asbestos. Minor repairs should also be done by
professionals since there is always a risk of exposure to fibers when
asbestos is disturbed.
Doing minor repairs yourself is not recommended since improper handling
of asbestos materials can create a hazard where none existed. If you
nevertheless choose to do minor repairs, you should have as much
information as possible on the handling of asbestos before doing
anything. Contact your state or local health department or regional EPA
office for information about asbestos training programs in your area.
Your local school district may also have information about asbestos
professionals and training programs for school buildings. Even if you
have completed a training program, do not try anything more than minor
repairs. Before undertaking minor repairs, carefully examine the area
around the damage to make sure it is stable. As a general matter, any
damaged area which is bigger than the size of your hand is not a minor
repair.
Before undertaking minor repairs, be sure to follow all the precautions
described earlier for sampling asbestos material. Always wet the
asbestos material using a fine mist of water containing a few drops of
detergent. Commercial products designed to fill holes and seal damaged
areas are available. Small areas of material such as pipe insulation
can be covered by wrapping a special fabric, such as rewettable glass
cloth, around it. These products are available from stores (listed in
the telephone directory under Safety Equipment and Clothing") which
specialize in asbestos materials and safety items.
Note: Removal is usually the
most expensive method and, unless required by state or local
regulations, should be the last option considered in most situations.
This is because removal poses the greatest risk of fiber release.
However, removal may be required when remodeling or making major
changes to your home that will disturb asbestos material. Also, removal
may be called for if asbestos material is damaged extensively and
cannot be otherwise repaired. Removal is complex and must be done only
by a contractor with special training. Improper removal may actually
increase the health risks to you and your family.
 This work is licensed under a Creative Commons Attribution-Noncommercial-No Derivative Works 2.5 License.
|